4924579 920089 scsi 13 Direct-Access WD 3200BMV External 05 PQ ANSI 49

 1
 2
 3
 4
 5
 6
 7
 8
 9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
[4924579.920089] scsi 13:0:0:0: Direct-Access WD 3200BMV External 1.05 PQ: 0 ANSI: 4
[4924579.922707] sd 13:0:0:0: [sdb] 625142448 512-byte hardware sectors (320073 MB)
[4924579.923705] sd 13:0:0:0: [sdb] Write Protect is off
[4924579.923710] sd 13:0:0:0: [sdb] Mode Sense: 21 00 00 00
[4924579.923713] sd 13:0:0:0: [sdb] Assuming drive cache: write through
[4924579.924736] sd 13:0:0:0: [sdb] 625142448 512-byte hardware sectors (320073 MB)
[4924579.926291] sd 13:0:0:0: [sdb] Write Protect is off
[4924579.926296] sd 13:0:0:0: [sdb] Mode Sense: 21 00 00 00
[4924579.926299] sd 13:0:0:0: [sdb] Assuming drive cache: write through
[4924579.926303] sdb: sdb1
[4924579.967171] sd 13:0:0:0: [sdb] Attached SCSI disk
[4924579.967248] sd 13:0:0:0: Attached scsi generic sg2 type 0
thresh@snowwhite ~ $ sudo fdisk /dev/sdb1
The number of cylinders for this disk is set to 38912.
There is nothing wrong with that, but this is larger than 1024,
and could in certain setups cause problems with:
1) software that runs at boot time (e.g., old versions of LILO)
2) booting and partitioning software from other OSs
(e.g., DOS FDISK, OS/2 FDISK)
Command (m for help): p
Disk /dev/sdb1: 320.0 GB, 320070288384 bytes
255 heads, 63 sectors/track, 38912 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk identifier: 0x73696420
This doesn't look like a partition table
Probably you selected the wrong device.
Device Boot Start End Blocks Id System
/dev/sdb1p1 ? 119512 153402 272218546+ 20 Unknown
Partition 1 does not end on cylinder boundary.
/dev/sdb1p2 ? 82801 116350 269488144 6b Unknown
Partition 2 does not end on cylinder boundary.
/dev/sdb1p3 ? 33551 120595 699181456 53 OnTrack DM6 Aux3
Partition 3 does not end on cylinder boundary.
/dev/sdb1p4 * 86812 86813 10668+ 49 Unknown
Partition 4 does not end on cylinder boundary.
Partition table entries are not in disk order
Command (m for help):